|
HID-446 installation instructions
Please note: This kit requires
the use of solder less connectors to factory loom “will not”
plug into factory harness.
• Remove factory bulbs, and replace with Vision X HID bulbs
(put a dab of silicone on outer lip of bulb after installed)
• Mount each Vision X ballast to the left or right of the
stock upper shock mount. Please note: On some applications
you will be required to drill and bolt through plastic skirt
(we also suggest a little silicone on back of ballast,
vibration dampener)
• At this time you will need to peal the protective loom
back from the factory loom about 4”. Cut the stock connector
and bulb off, (the 4” is in case you decide to go back to
stock bulbs).
• The majority applications that this kit fits has a
Yellow/Brown and Green power wires; you will “Not” use the
Yellow wire (High Beam) for this install. High beam not used
in HID.
• At this time you will splice the Vision X Ballast to the
stock wire loom.
• Splice the:
* Yellow wire at the Vision Ballast to the Green wire
*Black wire at the Vision X ballast to the Brown wire
Please duplicate for both sides (passenger and driver side)
• The yellow wire is the high beam power; you won’t have or
need high beam.
Know the bulbs are in, and the Ballasts are wired to the
loom, some vehicals with a front hood, will only open about
half way after this kit is installed, so closed and plug the
bulbs into the ballasts.
“Note” In order to open hood completely, you will have to
disconnect bulbs every time. If you activate “High Beams”
the lights will shut off.
|
HID-446.doc
HID-446.pdf
