HID-116 installation instructions

Installing HID Kit (04-05 Rhino upgrade #06RH needed)

Remove factory halogen bulbs from stock housings, install new supplied HID Bulbs. Do not touch these bulbs with fingers, if so wipe thoroughly with soft clean cloth.  Leave factory bulbs hanging there for later instructions (for 04-05 Rhino, Install upgrade housings before you start this installation)

Now plug the bulb red and white wires into the red and white wires off the supplied ballast, after this is done find a position to mount each ballast that will be out of the way of moving parts. You cannot extend these power wires at all!

After you find a place to mount ballasts use supplied hardware to do so, then on some applications (Rhino’s etc) you will unplug power wire from loom, on others you will need to unplug bulb at the end of factory connector (near bulb housing) use supplied Vision X power lead to plug into each Vision X ballast, the the opposite end will either plug into stock harness or where the stock halogen bulb is plugged in.

Again this application has multiple vehicles it can fit so please be patient and allow approximately 1-2 hrs to install.

Before using wire ties please start vehicle and test, if lights don’t turn on check power lead(oval) into ballast to make sure it’s not installed upside down (180 degrees out). If lights flicker or blow factory fuse and then turn off, you will need to use Vision X relay harness. If it’s not in box please call Vision X (800) 994-4460 this is N/C. The flicker or fuse popping can be caused by lack of power or a tired battery, the relay harness is N/C and will fix this.

After you get the lights to work, tie up all loose wires and enjoy!

Copyright Vision Motor Sports ©2008