|
07, 08, 09 Polaris Ranger
installation instructions
Installing the new HID bulb:
Remove the factory bulbs from headlight
housing by twisting Ό turn and pulling
outward, unplug bulb from wire
harness and store for possible future use. Install new
Vision X HID bulb being
careful not to touch the glass part of the bulb, if you do
please
wipe clean with an alcohol
solution.
Installing the new Vision X
HID Starter Ballasts:
Remove front truck area hood, place one
starter ballast (with connectors facing
upwards) in each lower corner
of the trunk space area (dont not use mounting 3M tape
yet). Drill a 7/8 hole through
plastic truck area in the upper left and right hand side of
inner trunk area so both the
power and output wire can fit through.
Wiring up the lights and
ballast:
Feed the 2 power and ground wires through
trunk opening one at a time, and plug into
bulb at the back of headlight
housing. Take the supplied 10 wire harness and plug one
end into the factory wire
harness (for power) and feed the other end through the 7/8
hole and plug into the Vision X
HID Ballast. After the power wire and bulb are connected
start the Ranger and make sure
they light up.
Mounting the Ballast:
Remove the protective paper from both
sides of the 3M pad and stick to the bottom of
the ballast and place in the
trunk area (make sure the area is clean). Use the supplied
zip ties to tie up any extra
length that might interfere with any moving parts. The trunk
area is not sealed from the
factory but if you choose you can seal up the 7/8 opening
with silicone, the weathers will not affect
our Vision X parts. |
